Beurer AS 50 Gebrauchsanleitung Seite 14

Only change between belt clip and wristband if necessary.
Changing too frequently wears out the material of the wrist-
band.
Wearing the activity sensor on your belt/trouser waistband
You can attach your activity sensor to your belt or your trouser waist-
band with the supplied belt clip. To do this, put the activity sensor into
the belt clip as follows:
Put the casing into the belt clip. Pay
attention that the USB connector (1) is
fixed on the side of the clip with the
notch.
The casing has to be firmly and directly
attached to the belt clip, it must not be
loose. Otherwise there is a risk of the
device detaching itself and possibly
getting damaged.
Removing the activity sensor from the
belt clip:
There is a small groove between the
belt clip and the activity sensor. Put
your fingernail into this groove and
press slightly to separate the belt clip
and the activity sensor.
Do not pull on the buttons! Nicht an den Knöpfen ziehen!
12