Operation; Specifications - Monacor MKA-50BSET/SW Bedienungsanleitung

4.1 Connecting the right speaker system
Connect the amplifier output RIGHT LS OUT (7) on
the rear of the left speaker system to the terminals
of the right speaker system using a speaker cable.
Always observe the correct polarity (connect the
terminals of the same colour).
4.2 Connecting the signal source
Connect the output of a signal source with line level
(e. g. CD player, output of a mixer, line output of a
computer or TV set) to the RCA jacks LINE IN (8)
on the rear of the left speaker system (L = left chan-
nel, R = right channel).
4.3 Power supply
Connect the mains cable provided to the mains
jack (3) on the rear of the left speaker system
and connect the mains plug to a mains socket
(230 V~/50 Hz).

5 Operation

CAUTION Never adjust the audio system to a
very high volume. Permanent high
volumes may damage your hearing!
Your ear will get accustomed to high
volumes which do not seem to be that
high after some time. Therefore, do
not further increase a high volume
after getting used to it.
1) Set the control VOLUME (9) to MIN (left stop),
and then switch on the speaker system with the
switch POWER (5). The LED ON (1) lights up.
The LED BT (2) lights up briefly.
2) Use the control VOL to adjust the desired vol-
ume. Only turn up the control to such an extent
that the sound reproduced will not be distorted.
3) Use the controls BASS (6) and TREBLE (4) to
adjust an optimum sound.
4) After use, switch off the speaker system with the
switch POWER.
All rights reserved by MONACOR
may be reproduced in any form or by any means for any commercial use.
5.1 Bluetooth signal source
To reproduce signals from a mobile device (e. g.
mobile phone, computer) via wireless Bluetooth
connection: With the speaker switched on, select
the speaker in the device list (designation "MS
Audio") and make a connection. Start the repro-
duction on the mobile device.
the speaker will automatically switch off the signal
at the analog input LINE IN (8).
Note: To allow signal transmission, the Bluetooth signal
source must support the A2DP profile (Advanced Audio
Distribution Profile).

6 Specifications

Frequency range: . . . . . . 60 – 20 000 Hz
Amplifier power: . . . . . . . . 2 × 10 W
Max. SPL: . . . . . . . . . . . . 100 dB for each
Input sensitivity: . . . . . . . . 320 mV
Tone controls
Connections
Bluetooth
Power supply: . . . . . . . . . 230 V~ / 50 Hz, 70 VA
Ambient temperature: . . . 0 – 40 °C
Dimensions (W × H × D): . 160 × 260 × 160 mm
Weight (pair): . . . . . . . . . . 4.5 kg
Subject to technical modification.
® INTERNATIONAL GmbH & Co. KG. No part of this instruction manual
When a Bluetooth connection has been made,
BASS, TREBLE: . . . . . ±10 dB
Signal input: . . . . . . . . . RCA jacks (L, R)
Speaker: . . . . . . . . . . . terminals (+, −)
Version: . . . . . . . . . . . . 4.0
Operating range: . . . . . approx. 10 m (class 2)
,
RMS
2 × 20 W
MAX
speaker system
GB
7