Installation; Setting Into Operation; Specifications - Monacor WALL-05SET/WS Bedienungsanleitung

2 Applications
This versatile active speaker set is suited both for
home applications and professional applications,
e . g . presentations . The set includes an active
speaker (speaker with amplifier) for the left chan-
nel and a passive speaker (without amplifier) for
the right channel .

4 Setting into Operation

Connection
Control element
Making connections
OUTPUT
RIGHT SPEAKER
INPUT
230 V~ / 50 Hz
FUSE
Operation
POWER
VOL
BASS + TREB
—

5 Specifications

Model
Output power
Power rating
Maximum power
Frequency range
Input sensitivity/ Input impedance
RCA jacks, unbal .
Screw terminals, bal .
Bass speaker
Tweeter
Connection impedance of passive speaker
Max . SPL
Power supply
Power consumption for operation / standby
Ambient temperature
Dimensions (W × H × D), weight (pair)
All rights reserved by MONACOR
reproduced in any form or by any means for any commercial use.
Function
Connect the passive speaker to this output . Observe the correct polarity (do not
confuse positive and negative connections) .
Connect the signal source (e . g . MP3/CD player, mixer) to the RCA jacks or to the
screw terminals . The screw terminals can be disconnected to make handling easier .
Connect the mains connection jack to a mains socket (230 V/ 50 Hz) via the mains
cable provided . — The fuse holder
replace a blown fuse by one of the same type!
Switching on / off . Before switching on, set the control VOL to MIN to make sure that
the initial volume is not too high .
The power LED ON will light up when the active speaker has been switched on .
Use the control to adjust the desired volume .
Use the controls to adjust the sound .
The active speaker will go to standby after approximately 3 .5 minutes if there is no
input signal . The LED ON will go out . As soon as a signal is present, the speaker will
switch on again .
INTERNATIONAL GmbH & Co. KG. No part of this instruction manual may be
®

3 Installation

Use the mounting brackets to install the speaker at
a suitable place on a wall . When the speakers are
ready for operation, align them optimally towards
the listening area .
⏛
is below the mains connection jack . Always
WALL-05SET / WS
2 × 30 W
2 × 50 W
80 – 20 000 Hz
500 mV/ 20 kΩ
660 mV/ 40 kΩ
13 cm (5") bass speaker
dome tweeter
8 Ω min .
104 dB
230 V/ 50 Hz
100 VA / 0 .4 VA
0 – 40 °C
163 × 252 × 203 mm, 5 .5 kg
WALL-06SET / WS
2 × 30 W
2 × 50 W
70 – 20 000 Hz
890 mV/ 20 kΩ
1600 mV/ 40 kΩ
16 cm (6") bass speaker
dome tweeter
8 Ω min .
105 dB
230 V/ 50 Hz
140 VA / 0 .5 VA
0 – 40 °C
196 × 303 × 250 mm, 8 .05 kg
Subject to technical modification .
7