Conformity And Approval; Setting Into Operation; Setting Up The Active Speaker System; Connecting The Active Speaker System - Monacor TXA-604/SW Bedienungsanleitung

3.1 Wireless microphones and
transmitters
The following units are available from MONACOR:
Type
Hand-held wireless
microphone
Pocket transmitter with
tie clip microphone and
headband microphone
Transmitter with line level
input for audio signals

3.2 Conformity and approval

Herewith, MONACOR INTERNATIONAL declare
that the active speaker system TXA-604/ SW
complies with the directive 2014 / 53 / EU . The
EU declaration of conformity is available on the
Internet:
www .monacor .com
The active speaker system is generally approved
for operation in EU and EFTA countries; it is
licence-free and requires no registration.

4 Setting into Operation

4.1 Setting up the active speaker
system
Place the active speaker system as desired or
mount it onto a PA speaker stand (e . g . PAST
series from MONACOR) via the stand sleeve on
its lower side .
The unit can be operated inside its transport
bag: Unzip the zip fasteners of the flaps covering
the speakers, the connections and the operating
elements . Fold up the flaps and secure them
with hook-and-loop fasteners .

4.2 Power supply

The speaker system is supplied with power via
the integrated battery which is charged via the
internal charger .
1) To charge the battery, connect the mains
cable provided to the mains jack (20) and con-
nect the mains plug to a socket (230 V/ 50 Hz) .
2) The LED CHARGE (8) lights up:
red = the battery is being charged
12
Model
TXA-800HT
TXA-800HSE
TXA-800ST
green = the charging process has been com-
pleted
The unit may be operated while its battery
is charged; however, as long as the red LED
LOW lights up, the full power is not available .
To reduce the charging time, switch off the
unit with the POWER switch (16) .
3) When the battery has been fully charged, the
LED CHARGE lights up in green . At maximum
volume, a mains-independent operating time
of up to 10 hours will be possible . A lower
volume will extend the operating time .
4) Recharge the battery when the red LED LOW
lights up .
Important!
Always disconnect the mains plug from the
socket when the battery has been fully charged
(LED CHARGE lights up in green) and the unit
is not operated; otherwise, the battery may
be damaged .

4.3 Connecting the active speaker system

Unit
Microphone with XLR
plug
Audio units with line
output, e. g.: mixer,
MP3 / CD player, radio,
microphone preamplifier
Active speaker system
Passive speaker system
Connection to jack
MIC / LINE (4)
LINE IN (9) and
with 6.3 mm plug to
MIC / LINE (4) if no
microphone is connected
LINE LINK (10)
If a second speaker
system TXA-604 / SW is
used, connect its input
LINE IN to the output
LINE LINK of the first
speaker system.
EXTERNAL SPEAKER (18)