Safety Note - Vevor T5 Bedienungsanleitung

Anchoring hardware requirements:
Once the wood blocking is in place and the wall finish has been installed,
position the shower seat at the required height, normally 17-19inches
above the floor, Use a marker to mark the flange and wall bracket screw
locations. Use a punch and hammer to carefully nick the tile to prevent the
drill bit from wandering. Use a masonry bit and drill through the tile. All
anchoring hardware must be carefully selected to ensure proper
installation.
OUR SHOWER SEATS ARE ONLY AS STRONG AS THE MOUNTING
HARDWARE CHOSEN AND THE WALLS ON WHICH THEY ARE
MOUNTED.

SAFETY NOTE:

Concealed In-Wall support backing is ALWAYS REQUIRED for this product
(not included) - and must be supplied and selected by a Licensed
installer/contractor to meet both weight bearing and local code
requirements.PRODUCT INSTALLATION SHOULD BE DONE BY A
LICENSED INSTALLER/CONTRACTOR.
CAUTION:
Personal injury and/or property damage may result from improper wall
support or mounting, which is not covered under warranty.
Please Read Disclaimer
The manufacturer or distributor of this product shall not be held liable for
installation actions taken or not taken. There are many details of
installation that are assumed to be general construction knowledge to
experienced installers; which are not included in these instructions.
Selection of an experienced installer is the sole responsibility of the home
owner or architect
4