cecotec LONGFLEX 710 PRO Bedienungsanleitung Seite 9

ENGLISH
e. Check the power tool and its accessories. Check if the
moving parts are misaligned or stuck, if there are broken
pieces or any other condition that may affect the power
tool's operation. In case of damage, the power tool must
be repaired before use. Many accidents are due to poorly
maintained power tools.
f. Keep accessories clean and sharp. Properly maintained
accessories are better guided and controlled.
g. Use the power tool, accessories, etc. according to these
instructions, taking into account the working conditions
and the work to be carried out. The use of power tools for
work other than that for which they are intended can be
dangerous.
h. Keep handles and gripping surfaces dry, clean and free
of oil and grease. Slippery handles and grasping surfaces
do not allow safe handling and control of the tool in
unexpected situations.
Service
a. Only have your power tool repaired by a qualified expert,
using only original spare parts. This is the only way to
maintain the safety of the power tool.
Safety Instructions for Reciprocating Saws
a. Hold the power tool by insulated gripping surfaces when
performing an operation where the cutting accessory may
contact hidden cables or its own cable. Contact of the
cutting accessory with a "live" wire may cause exposed
metal parts of the power tool to become "live" and could
give the operator an electric shock.
b. Use clamps or other practical means to secure and support
the workpiece on a stable platform.
16
LONGFLEX 710 PRO ORIGINAL INSTRUCTIONS
c. Holding the workpiece with the hands or against the body
makes it unstable and can lead to loss of control.
d. Keep hands away from the cutting area. Do not reach
under the workpiece. You could be injured by touching the
saw blade.
e. While working, hold the power tool firmly with both hands
and take care of a safe position. By using both hands the
power tool is guided more safely.
f. Only bring the power tool in operation close to the
workpiece. Otherwise, the tool may suddenly move
backwards when the tool gets caught in the workpiece.
g. Make sure that the base plate is always applied to the
workpiece during sawing. The saw blade can snag and lead
to loss of control over the power tool.
h. At the end of the work process, switch off the power
tool and wait until it has come to a complete stop before
removing the saw blade from the cutting groove. This
allows you to safely deposit the power tool without the
risk of the power tool kicking back abruptly.
i. Wait until the power tool has stopped before putting it
down. The saw may snag and cause you to lose control of
the power tool.
j. Only use undamaged saw blades in perfect condition.
Deformed or dented saw blades may break, impair the
quality of the cut, or cause the unit to kick back.
k. After switching off the unit, do not try to brake the saw
blade by pushing it sideways. The saw blade could be
damaged, break or cause the unit to recoil abruptly.
l. Firmly fix the material. Do not support the workpiece with
your hand or foot. Do not touch any objects or the floor
with the saw in operation. There is a danger of counter-
attack.
ORIGINAL INSTRUCTIONS
ENGLISH
17
LONGFLEX 710 PRO