Maintenance And Cleaning - IKEA FIXA Übersetzung Der Originalbetriebsanleitung

discharged. Unscrew the screws in
the casing and take off the casing shell.
Disconnect the connections on the battery
and remove the battery (see illustration A).
INSTRUCTIONS FOR USE
Using the tool
Mounting drill/driver bits
Before any work on the machine (e.g.
maintenance, tool change, etc) as well as
during transport and storage, set
direction switch to the centre position.
Unintentional actuation of the trigger can
lead to injuries. Adjust the chuck until the
opening is slightly larger than the shaft
of the drill bit that you wish to use. Insert
the drill bit into the chuck. Tighten the
chuck against the drill as described below
(Keyless chuck).
Regulating the shaft speed
It is possible to regulate both shaft
speeds from zero to maximum by altering
the pressure applied to the trigger. This
enables you to choose the optimum speed
for the task you are working on. Use
the lower speed for tightening/loosening
screws (position 1 on the gear selector
(3)).
Selecting shaft speed
Use a low speed when starting to drill in
metal, plastic or ceramic materials, using
the screwdriver function or carrying out
work that requires a high degree of torque.
Use a high speed when drilling in wood.
(position 2 on the gear selector (3)).
Reversing the direction of rotation
You can reverse the direction of rotation by
using the rotational direction switch
To lock the trigger, set the selector to the
mid position between the right and left
options.
Adjusting the tightening moment
Turn the torque regulator (2) to the
desired position. Settings 1-19 are used for
tightening/loosening screws (the higher the
value, the greater the tightening moment).
Select the drill symbol before using the tool
for drilling.
Keyless chuck
rotational
Your drill has a keyless chuck so that you
can simply tighten or release drill/driver
bits.
To open/close the chuck hold the rear
(10) and rotate the front sleeve (11).
Do not hold the front sleeve of the chuck
with one hand at the same time as you
open or close the jaws of the chuck with
the help of the screwdriver/drill's motor.

MAINTENANCE AND CLEANING

Before any work on the machine (e.g.
maintenance, tool change, etc) as well
as during transport and storage,
the rotational direction switch
centre position.
of the trigger can lead to injuries.
For safe and proper working, always
keep the machine and ventilation slots
clean.
(4).
WARNING: RISK OF TRAPPING
Unintentional actuation
10
ring
set
to the