Preparing For Start-Up - Kärcher RC 3 Premium Originalbetriebsanleitung

Preparing for start-up

Unpacking the Appliance
The packaging material can be recycled. Please
do not place the packaging into the ordinary re-
fuse for disposal, but arrange for the proper re-
cycling.
Scope of delivery
Part
Cleaning robot
Station
Battery
Filter (pre-installed)
Power supply unit
Side brush
Cleaning brush
Screwdriver
Screw
Rubber brush
(already installed in the appli-
ance)
Brush roller
(already installed in the appli-
ance)
 When you unpack the system, check that every-
thing is complete.
If there are any missing parts or you detect any
transport damage when unpacking, please inform
your dealer immediately.
Insert the battery in the battery compartment
Illustration
 Connect the cable plug of the battery to the cable
plug in the battery compartment.
 Press the battery latch inwards in the direction of
the arrow at the same time and allow the battery to
latch into position in the battery compartment.
Assemble the appliance
Illustration
 Tightly screw on the side brush.
Installing the station
Illustration
 Push the upper part of the station onto the base un-
til it engages.
Installation Notes for the Station
The station must be located in a position that can be
easily reached by the cleaning robot.
Illustration
 Clean the contact surfaces before you set up the
station.
 Set up the station so that there are no obstacles
1 m in front of it and 0.5 m at the sides.
 Set up the station likewise.
RC 3 RC 3
Premium
Piece Piece
1 1
1 1
1 1
2 3
1 1
1 2
1 1
1 1
2 2
1 1
1 1
EN
Operation
Preparation for cleaning
Caution:
Prior to using the cleaning robot, please make sure that
there are no obstacles, such as on steps or thresholds.
Obstacles can be, for example:
– Newspapers, books, magazines, paper
– Clothes, toys, CDs
– Plastic bags
– Bottles, glasses
– Curtains hanging down on the floor
– Bathroom mats
Tips and Tricks
 Observe the cleaning robot during the initial clean-
ing process. Obstacles in the room that cannot be
overcome by the appliance, should be removed
ahead of time. This will avoid undesired interrup-
tions.
 Clean up the room just like you would if you were
vacuuming prior to using the cleaning robot. Do not
leave loose objects on the floor.
 Tie up cables, strings, and curtains to prevent the
robot from pulling them down.
 Take care to ensure that the battery is fully charged
and remove the battery when storing the device for
longer than 4 months.
 When cleaning a room, make sure all doors are
closed.
 When cleaning a whole level, make sure that the
cleaning robot will not be able to travel behind
doors.
Illustration
 Insert the charging plug into the station connection.
 Connect the mains plug to a suitable socket.
Illustration
 Switch on the cleaning robot.
The cleaning robot emits an audible signal.
The signal light flashes for approx. 15 sec. and
then lights up constantly.
The cleaning robot is in standby.
Illustration
 Put the cleaning robot on the floor in front of the sta-
tion.
 Push the cleaning robot carefully onto the charging
station.
The charging process starts when the signal
sounds.
 Push the Start button to switch on the cleaning ro-
bot.
Note: Do not change the position of the charging
station after the cleaning robot has departed from
the charging station. Otherwise the cleaning robot
is no longer able to find the charging station.
– 9
Start up
17