Starting Up; Turn Unit On; Settings; Operation - AEG DVD 4621 HC Bedienungsanleutung

Turn Unit On

Settings

Generally Valid Buttons

Starting Up

‹ First turn the unit on with the main switch (13). Later press
on the unit or POWER on the remote control to turn the unit on
and off.
The display (4) shows ON.
NOTE
►
After being turned on the unit goes into the previous mode.
Press SOURCE (unit button (6), remote control button (23)) to
select other signal sources (Radio, AUX1 or AUX2).
‹ Turn your TV set on and select the correct video mode, i.e.
corresponding to the selected connection (component video,
S-video, etc.).
Set DVD 4621 HC as required.
‹
Settings and access of the settings is described in chapter Menus.
Settings and access of the settings is described in chapter Menus
"General Setup" under TV Display and in menu "Video Setup".

Operation

Following remote control buttons have the same meaning for all DVD
4621 HC functions:
■
Press POWER (1) to turn the unit on/off.
■
Press MUTE (26) to mute the sound; press again to unmute.
■
Use the numeric buttons (4) to enter chapter numbers, station
frequencies, etc. Numbers greater than 10 enter with 10+ (5),
repeatedly if necessary.
■
Press VOLUME (24) to increase (+) or decrease (-) the volume.
■
Press CHANNEL (9) to change the volume setting for each channel.
■
Press  REV,  FWD (18, 17) for fast forward/ rewind functions
(movie, music, station search).
■
Press  CH+,  CH- (31, 32) in playback mode (movie chapter,
music title, station preset) to skip forward/back.
■
Press SOURCE (23) to select a signal source: DVD, Radio, AUX IN.
■
Press SETUP (6) in DVD mode to access the settings menu (see
chapter Menus).
■
Press PROLOGIC II (29) to activate/deactivate the Prologic settings.
English
43
(1)