Profi-Partner JS-PHA0118 Handbuch Seite 36

Problem Reason
Viscosity of coating material too high
Material volume adjusting screw turned
too far to the upside (+)
Atomization too
coarse Nozzle contaminated
Air filter heavily soiled
Too little pressure build-up in container
Coating material in container running out
Spray jet pulsates
Air filter heavily soiled
Coating material Too much coating material applied.
causes "paint
tears"
Technical Data:
Model
Customer Art. No.
Rated Voltage
Rated Power
Protection Class
Max. Flow
Paint Reservoir
Nozzle
ATTENTION!!!
The returns will be impossible if products were damaged because of incorrect use.
DISPOSAL：
The packaging material is reusable. Dispose of the packaging in an environmentally friendly way by putting it in
the appropriate recyclable waste collection containers.
Dispose of the product and the batteries in view of the environment if you want to separate. The
device and the batteries must not be thrown in with domestic waste. Take them to a recycling
center for used electrical and electronic devices. For more information you can consult your local
government. Remove batteries first.
Eurotops Versand GmbH
Elisabeth-Selbert-Straße 3
40764 Langenfeld, Germany
If technical support is needed, please call ...
in Germany 0180 . 530 63 63* or
in Austria 0720 204 001 or
in Switzerland 071/27 4 68 06 or
in the Netherlands 020262 1958 or
in France 0892 . 700 470** or
in Belgium
* 14 Cents/minute via German landline, max. 42 cents/minute via mobile phone network
**34 Cents/minute via French landline
A possible return of products should be addressed to the return address stated on your invoice.
©1.01.2020
info@eurotops.de
info@eurotops.at
info@eurotops.ch
info@eurotops.nl
info@eurotops.fr
070 663 665*** or info@eurotops.be
Solution
Thin
Turn material volume adjusting
screw to the downside (-)
Clean
Change
Tighten container
Refill
Change
Turn material volume adjusting
screw to the downside (-)
JS-PHA0118
45189
220-240V, 50-60Hz
550W
Class II
1200ml/min
1300ml
1.8mm and 2.6mm
GB