Profi-Partner JS-PHA0118 Handbuch Seite 33


Place the container on a sheet of paper, pour in the prepared coating material and screw the container
tightly onto the spray gun.

Put the machine down on a level surface. Otherwise the machine could tip over!

Adjust the spray setting on the spray gun.
Three different spray jet settings can be chosen on the spray gun, depending on the application and
target object.
Selecting the Spray Setting
Fig. 3
Fig. 3 B = circular jet
Fig. 3 C = vertical fat jet
Fig.3
3A
The spray pattern indication can be found on the front part of the sprayer with the arrowhead towards the boss
on the tip (Fig.4).
WARNING!
Adjusting the Material Volume (Fig. 5)
Set the material volume by turning the flow knob 9 on the trigger.
- turn downside
+ turn upside
Note: Small material volume can help get a fine finish.
3B
Danger of injury! Never pull the trigger guard while adjusting the air cap.
lower material volume
higher material volume
Spray pattern indicator
3C
GB
Boss on the tip
Fig.4