Profi-Partner JS-PHA0118 Handbuch Seite 30

4. Power tool use and care
a. Do not force the power tool. Use the correct power tool for your application. The correct power tool will
do the job better and safer at the rate for which it was designed.
b. Do not use the power tool if the switch does not turn it on and off. Any power tool that cannot be
controlled with the switch is dangerous and must be repaired.
c. Disconnect the plug from the power source and give the device time to cool down before making any
adjustments, changing accessories, or storing power tools. Such preventive safety measures reduce
the risk of starting the power tool accidentally.
d. Store idle power tools out of the reach of children and do not allow persons unfamiliar with the power
tool or these instructions to operate the power tool. Power tools are dangerous in the hands of
untrained users.
e. Maintain power tools. Check for misalignment or binding of moving parts, breakage of parts and any
other condition that may affect the power tools operation. If damaged, have the power tool repaired
before use. Many accidents are caused by poorly maintained power tools.
f. Use the power tool, accessories and tool bits etc., in accordance with these instructions and in the
manner intended for the particular type of power tool, taking into account the working conditions and
the work to be performed. Use of the power tool for operations different from intended could result in a
hazard- ous situation.
g. Damaged switches must be replaced at a customer service repair centre. The mains cable may only
be replaced by the manufacturer, the manufacturer's customer service department or equally qualified
persons.
h. Do not use power tools that cannot be switched on and off.
i. Do not leave power tools unattended while they are switched on. Always switch off the tool and wait
until it stops completely before leaving.
5. Service
Please use a qualified expert who uses original replacement parts to repair your power tool. This will ensure
proper functioning of the power tool.
Safety Instructions for Spray Guns
Never point the spray gun at yourself, at other people or at animals.

Only use products with a flash point of 55° C or higher. Always follow the instructions provided by the paint
manufacturer.

The device may not be used in workplaces covered by the explosion-protection regulations.

There must be no sources of ignition, for example, open fires, smoke of lit cigarettes, cigars and tobacco
pipes, sparks, glowing wires, hot surfaces, etc. in the vicinity during spraying.

Do not spray any substances whose hazard potential is not known.

Before working on the spray gun remove the power plug from the socket.

Do not use the spray guns to spray flammable substances.

The spray guns are not to be cleaned with flammable solvents which have a flashpoint under 55° C.

Caution against dangers that can arise from the sprayed substance and observe the text and information
on the containers or the specifications given by the substance manufacturer.

When working with the tool indoors as well as outdoors, ensure that no solvent vapors are sucked in by
the spray gun.
Recommendation：Wear breathing mask, safety glasses and protection
gloves when spraying.
GB