Profi-Partner JS-PHA0118 Handbuch Seite 32

Preparation of the Coating Material
The enclosed spray attachment can be used to spray paints, varnishes and glazes that are undiluted or slightly
diluted.
1. Stir the material up and put the required amount into the paint container
Thinning recommendation
Sprayed material
Glazes
Wood preservatives, mordant, oils, disinfection agents, plant protective agents
Paints containing solvents and water-soluble paints, primers, vehicle coating
paints, hick-flm glazes
2. If the convey capacity is too low, add 5 - 10% dilution step-by-step until the convey capacity fulfills your
requirements.
Note: Do not over dilute the paint. This will reduce the paint performance. Never exceed
the dilution advice on the paint container. If the paint can't spray out, change the nozzle
to a bigger one. If still can't spray out, this spray gun may not suitable for this paint or
there is something wrong on the spray gun.
Start-up

Insert the cord coupler to the gun outlet.
Note: the coupler is designed undetectable. Do not try to detach the coupler.

Unscrew the container from the spray gun.

Aligning suction tube. (Fig. 2)
When working on lying objects: Turn the suction tube forwards. (Fig. 2 A)
Spraying work when working on overhead objects: Turn the suction tube rearwards. (Fig. 2 B)
Fig.2
A
GB
Dilution advice
undiluted
undiluted
dilute by 5 - 10%
B