Emptying The Product; Storage, Cleaning - Playtive Inflatable Water Sprinkler Gebrauchsanweisung

2. To inflate the product, open the valve seal and
inflate the air chambers of the support feet.
Close the valve seal and push in the valve by
pressing lightly (fig. B).
3. Inflate the main chamber and close the cap
(fig. C).
Inflate the air chamber until it feels firm to the
touch.
When you press with your thumb against each
air chamber it should still give a little. Close
the valve seal.
4. Connecting the garden hose
To connect a garden hose use a suitable hose
coupling and attach it to the product's water
connection (fig. D).

Emptying the product

To do so, open the seal of the water chambers
and let the water run out (fig. A).
Disassembly
Allow the product to dry completely before
folding it up.
Remove the garden hose.
Deflate the product as follows:
1. To deflate the main chamber rapidly, open the
lower seal (fig. E).
2. To deflate the other components pull out the
valve and squeeze the valve stem lightly so
that the air can escape or insert the deflation
tube into the valve to allow the air to escape
rapidly.
Repairs
Minor leaks or holes can be repaired with the
repair patch supplied.
Important!
Do not inflate the product for 20 minutes after
repair! Do not use the patch for leaks or holes
on the seam.
1. Let the air out of the product completely.
2. Clean the area around the leak thoroughly.
The area must be dry and free from grease.
3. Cut out a piece of the repair material that is
big enough for its edges to overlap the dam-
aged area by about 1.3cm.
4. Peel the patch off the paper, place it on the
damaged area and press tight.

Storage, cleaning

When not in use, always store the product clean,
dry and uninflated at room temperature. The
valves should always be closed during storage.
Clean the product only with water or soapy wa-
ter, never with abrasive detergents. When storing
for the winter do not put any sharp objects on
the product and do not apply talcum powder.
Disposal
Dispose of the article and the packaging materi-
als in accordance with current local regulations.
Packaging materials such as foil bags are not
suitable to be given to children. Keep the pack-
aging materials out of the reach of children.
Dispose of the products and the
packaging in an environmentally friendly
manner.
The recycling code is used to identify
various materials for recycling.
The code consists of the recycling symbol
– which is meant to reflect the recycling cycle –
and a number which identifies the material.
GB/IE/NI 5