Playtive INFLATABLE WATER SPRINKLER Gebrauchsanweisung Seite 4

Avoiding material damage!
• All inflatables are susceptible to cold. For this
reason never unfold and inflate the product at
a temperature lower than 15°C!
• Warning. Avoid using sunscreen and skin care
products containing alcohol. Sunscreen and
skin care products containing alcohol can
cause the colour coating of this PVC inflatable
product to peel.
This can lead to stains on your body, your
clothing and other objects that are in contact.
• In the event that the air pressure increases in
the hot sun, it must be balanced accordingly
by letting out air.
• Make sure that the product, especially when
inflated, does not come into contact with
stones, gravel, or sharp objects and does not
rub or scrape against anything as this can
cause damage to the plastic foil.
• Use only the correct pump adapters to insert
into the safety valves. The valves might other-
wise be damaged.
• Do not over-inflate because you then risk tear-
ing open the welded seams. Close the valves
properly after inflating.
• Avoid contact with sharp-edged, hot, pointed,
or dangerous objects.
Assembly
An adult should always assemble the
product. Please follow the individual
assembly steps in the order indicated.
1. Selecting the location
Choose a suitably flat and clean surface with
plenty of space to unpack and unfold the prod-
uct. Spread the product out in the place where it
will later be used.
4 GB/IE/NI
Check that all individual parts are present and in
good order and condition.
2. Inflation
Warning!
• Always inflate the air chambers fully!
• Avoid inflating the air chambers too
much because there is the risk of
over-stretching the welded seams or
even tearing them open.
• Use standard commercial foot pumps
or double-stroke piston pumps with
matching adapter attachments to
inflate the product.
• Do not use a compressor or com-
pressed air bottles to inflate the
product. This can lead to damage to
the product.
• Make sure that the chambers are
filled with air uniformly.
• Inflate each air chamber until it feels
firm to the touch. When you press
with your thumb against the air cham-
ber it should still give a little.
Sequence
WARNING!
Follow the correct sequence when inflat-
ing the air chambers. Always inflate all
air chambers fully.
1. Support feet
2. Main chamber
3. Inflation
1. For better support fill the feet with water first.
To do so, open the seal of the water chambers
and let clean water run in (fig. A).