Kit
KVU8571
T E C H N I C A L M A N U A L
UT8020
ULTRA AUDIO/VIDEO VIP MODULE
UT9171
WALL HOUSING FOR UT8020
UT9211
SINGLE ULTRA BUTTON
Name Surname
Kit monofamiliare
Gli articoli contenuti nel kit sono pre-programmati per
consentirne il funzionamento di base senza l'utilizzo
del software di programmazione VIP Manager. In
particolare tutte le porte di rete (LAN o Wi-Fi) sono
pre-programmate in modalità DHCP, ciò comporta
un'attesa di circa 90 secondi prima che l'impianto
sia pronto all'utilizzo. Schemi di collegamento
da pag. 4.
Art. 1441B
Alimentatore 30W, 4 moduli DIN.
70 mm
62 mm
Apparecchio da utilizzare solo per uso interno.
Pericolo di shock elettrico, procedere con
cautela. Installare in quadro elettrico chiuso
tale da consentire l'accesso solo a personale qualificato.
È necessario installare a monte dell'impianto
videocitofonico un appropriato interruttore di rete
onnipolare con apertura del contatto di almeno 3mm.
•
Togliere l'alimentazione prima di effettuare qualsiasi
operazione.
•
Rimettere le protezioni sui morsetti.
•
Non ostruire le aperture o fessure di ventilazione e di
dissipazione.
C H E C K F O R
U P D A T E S
The items included in the kit are pre-programmed
to allow basic operation without the use of the VIP
Manager programming software. In particular, all
network ports (LAN or Wi-Fi) are pre-programmed
in DHCP mode, which results in a wait of about 90
seconds before the system is ready for use.
Wiring diagrams
Art. 1441B
Power supply unit 30W, 4 DIN modules.
70 mm
4 moduli DIN
4 DIN modules
4 modules DIN
4 DIN-modules
4 DIN-Module
4 módulos DIN
4 módulos DIN
qualified personnel.
It is necessary to install an appropriate omnipolar mains
switch with a contact opening of at least 3mm upstream
of the door entry monitor system.
•
•
•
TP6842
7TOP VIP DOOR ENTRY MONITOR
1441B
30W VIP POWER SUPPLY UNIT
1440A
IP (VIP) FLOOR BRANCH
Single-family kit
from p. 4.
62 mm
Device for indoor use only. Risk of electric
shock, proceed with caution. Install in a secure
electrical cabinet so as to allow access only to
Disconnect the power supply before carrying out any
operation.
Replace the protections on the terminals.
Do not obstruct the ventilation or dissipation
openings or slots.
4 moduli DIN
4 DIN modules
4 modules DIN
4 DIN-modules
4 DIN-Module
4 módulos DIN
4 módulos DIN