Transport And Unloading; Commands And Functions; Fitting The Mower Deck; Hydraulic Lifting Of Mower Deck - Kubota Rc44C-Fc3 Bedienungsanleitung

9. TRANSPORT AND UNLOADING

The attachment is heavy and can lead to serious crushing injuries.
Load and unload it with caution.
Transport the attachment on a type-approved trailer.
During transportation, hold the attachment in place with the aid of type-approved belts, chains or ropes.
IMPORTANT: if the machine is packaged and placed on its pallet, it can be moved using a fork-lift. (Min-
imum capacity 100 kg).
If it is not on a pallet, move the brush using suitable straps.
Be careful - the central point of the machine doesn't correspond to its centre of gravity (the point of inter-
section of the dotted black lines).

10. COMMANDS AND FUNCTIONS

NOTE: The controls and operations described below refer to both mower deck models. If this is not the case, it
will be clearly indicated.
The mower unit is activated using the following controls:
1) Attachment lifting lever
2) Hopper lifting lever (*)
3) Hopper tilting lever
4) P.D.P. activation
*: only lift version "FC3".

11. FITTING THE MOWER DECK

1) Move the mower deck close to the machine and connect the cardan shaft pipes
2) Connect the machine lifter arms to the connections on the attachment
3) Fully push the mower deck and connect the turbine pipe
4) Insert the locking pins and the anti-slip split pins
5) Start up the machine and raise the attachment using the relative lever
6) Insert the safety prods and the relative anti-slip split pins
7) Lower the attachment using the relative lever, then switch off the machine
NOTE: See the FC3-221E multi-purpose machine technical manual.
12. COMMANDS AND FUNCTIONS

12.1 HYDRAULIC LIFTING OF MOWER DECK

Mower deck lifting lever

12.2 LIFT VERSION HOPPER TILTING

Only lift version "FC3"
1) Hopper lifting lever
2) Hopper tilting lever

12.3 HYDRAULIC HOPPER TILTING

Hopper tilting lever

12.4 POWER TAKE-OFF

13. MOWER DECK CUTTING HEIGHT ADJUSTMENT

13.1 112 DECK CUTTING HEIGHT ADJUSTMENT

WARNING: Make sure that the PTO is disengaged and that the blades are completely stationary.
Cutting height adjustment: 1-8 cm
10
See figure 9.
See figure 10.
See figure 11.
See figure 12.2
See figure 12.3
See figure 12.4
See figure 12.1
See figure 13.1.