Ripmax SIGMA E Q Mini Bedienungsanleitung Seite 12
Intelligentes balancer ladegerät mikroprozessorgesteuertes schnelllade-/entladegerät mit eingebautem balancer, usb pc link und temperatur sensor. ladestrom bis zu 4,5a, 1-4 zellen li-ion/li-fe, 1-10zelliger ni-cd/ni-mh, 2-12v bleiakku (pb)
Inhaltsverzeichnis
Verfügbare Sprachen
Verfügbare Sprachen
Care and Handling of NiMH Batteries
•
DO NOT allow NiMH batteries to overheat (above 50°C)! Disconnect overheated
batteries from the charger immediately and allow to cool.
•
DO NOT attempt to use the charger's lithium functions with NiMH batteries and
vice versa.
•
Store NiMH packs with some voltage remaining on the cells (refer to battery
supplier).
•
It is important to recharge NiMH batteries immediately prior to use, as they have a
higher self discharge rate.
Care and Handling of LiPo, Li-Ion and LiFe Batteries
•
WARNING! DO NOT try to charge lithium-polymer (LiPo) lithium-ion (Li-Ion) or LiFe
cells in the same way as other battery types! Always read the instructions that are
included with your lithium batteries carefully before use. Failure to follow these
care and handling instructions can quickly result in severe, permanent damage to
the batteries and their surroundings and even start a fire!
•
ALWAYS charge lithium batteries in a fireproof location, which could be a
container made of metal or ceramic tile. Monitor the area with a smoke or fire
alarm, and have a lithium approved fire extinguisher available at all times.
•
NEVER attempt to extinguish a lithium fire with water or a non-lithium approved
fire extinguisher! Use ONLY a Class D (CO2 or powder) fire extinguisher.
•
ALWAYS provide adequate ventilation around LiPo/Li-Ion/LiFe batteries during
charge, while in use, and during storage.
•
NEVER allow LiPo, Li-Ion or LiFe cells to overheat at any time as they can become
physicaly damaged and could possibly explode or catch fire! If a battery becomes
overheated (over 140°F, 60°C), disconnect it from the charger IMMEDIATELY.
•
NEVER continue to charge LiPo, Li-Ion or LiFe batteries if the charger fails to
recognise a full charge. LiPo and LiFe cells which swell or emit smoke may be in
overcharge condition and should be disconnected from the charger immediately.
•
NEVER set the charger's LiPo/Li-Ion or LiFe battery voltage settings to a voltage that
is HIGHER than the nominal rating of the battery itself, as such cells cannot handle
overcharging in any way.
- 12 -
Inhaltsverzeichnis
