MAX Systems LabelMax XL+ Kurzanleitung Seite 11

inSert/replAce filM
Insert/replace film
Press
Open the printer cover and press the
printhead release lever to open the
printhead mechanism.
Pull the leading edge of the label
roll forward through the media
guide rail, past the media sensor,
and onto the platen roller.
Film path:
Set the media sensor type via the front display and calibrate the selected sensor (see note on "Media sensor calibration").
Note: Recalibrate the gap/black mark sensors after each media change.
QUICKSTART GUIDE
1.
Remove a label roll cover.
4.
Loosen the fixing screw, adjust
the label guide to the width of the
labels, and tighten the screw again.
Output roller
Media sensor
2.
5.
Close the printhead mechanism and
Media supply spindle
Media guide rail
Place the media roll on the label
supply spindle and reattach the la-
bel roll cover. Note: Make sure that
the roll is centered on the spindle.
make sure the latches are properly
locked.
Label roll cover
EN
3.
6.
7.
11