MAX Systems MultiMax V8 Kurzanleitung Seite 11

inSert/replace filM
ca. 10mm ca. 10mm ca. 10mm
Move the right and left media
clamps to the edges of the film.
Software Settings OfflineUtility
>
Open the Utility software on your PC (Search → ConnectionCheck → OK → Wait → Open) and click „Setup" to load the film
Follow the instructions in the utility windows (select the
inserted media and confirm with "OK").
1
2
Click on the "Media Settings List" (1)
and scroll down to "Position Adjust-
ment for Printing & Cutting." Confirm
by clicking "Execute" (2).
Note: After each film loading, such a calibration pattern must be printed. Further detailed information on software settings in the
Utility App can be found in the SignMax v11 installation guide.
QUICKSTART GUIDE
9.
Close the loading lever and the front
cover again.
>
>
>
12.
1
3
14.
Then click "Output 1" (a test pattern
will be printed) (1). Click "Apply" (2)
and confirm by clicking "OK" (3).
10.
roll.
Perform the position adjustment for printing & cutting: Click
the 3 bars next to the status display "Print Ready."
2
15.
print and the SignMax sign software
>
The setup window can be closed.
The MultiMax v8 is now ready to
can be started.
EN
11.
13.
16.
11