MAX Systems MultiMax V8 Kurzanleitung Seite 10

inSert/replace filM
Insert/replace film
Inserting the film
Remove the media shaft („film roll
holder") from the device.
Reattach the left media flange to the
media shaft and secure it by closing
the locking lever in the direction of
the arrow.
Loading the film
Open the front cover and the
locking lever.
QUICKSTART GUIDE
1.
Open the locking lever on the left
media flange in the direction of the
arrow and remove the flange from
the media shaft.
4.
1
Insert the media shaft incl. film roll back into the printer. Avoid touching the print
surface (1). Press the left and right ends of the shaft into the holder until a click
is heard (2). On the right side, the small wheel must be positioned in the guide
2
6.
Move the left pinch roller (1) and
the left media clamp (2) to the left
end. And move the right pinch roller
and the right media clamp to the
right end.
2.
Place the film roll onto the media
shaft so that the film end is at the
front (viewed from above „clock-
wise"). This is necessary so the
film can be scanned in the correct
orientation.
2
rail (3).
1
1
7.
Pull out the film and feed it from
above the plate on the front side
(1). Pull the film to the front edge
(approx. 20 cm in front of the front
cover) (2). If necessary, rewind the
film slightly (3).
EN
3.
5.
3
2
3
8.
10