Changing The Single Hotkey - Guntermann & Drunck G&D DVIMUX2-DL-USB Bedienungsanleitung

Changing the single hotkey

Press the hotkey and the
KVM switch. Pressing the hotkey and the select key simultaneously enables the
switching of channels.
If an application program or another G&D device uses the same hotkey within the
cascade, the hotkey can be changed.
NOTE: The single hotkey
How to change the current hotkey:
1. Press the
Hotkey+Backspace
vate the setup mode.
If the hotkey delay is active, press the key combination for seven seconds.
2. Press one of the setup keys listed below to enable a certain hotkey:
 enables Ctrl hotkey
Ctrl
 enables Alt hotkey
Alt
Alt Gr  enables Alt Gr hotkey
 enables Win hotkey
Win
Shift  enables Shift hotkey
1. Use the terminal emulator to establish a connection to the KVM switch.
If the setup menu is not displayed, the Switch mode of the service port is
enabled. Enter »
2. Use the Arrow
3. Press the Space
Ctrl  enables Ctrl hotkey
 enables Alt hotkey
Alt
 enables Alt Gr hotkey
Alt Gr
Win  enables Win hotkey
 enables Shift hotkey
Shift
4. Press the S key to save your settings.
key simultaneously to start the setup mode of the
Backspace
is preset at default.
Ctrl
(default:
« to switch to the setup menu.
#!
or Arrow keys to select the
key (repeatedly) to enable a certain hotkey:
) simultaneously to acti-
Ctrl+Backspace
Hotkey entry.
G&D DVIMUX2-DL-USB · 19
Configuration