PRASTEL TCO7SG-KIT Benutzerhandbuch Seite 16

Receiver (RX) indicator lights:
Transmitter (TX) status
TX contact closed
or 8K2 present
TX contact open
Input 1
or 8K2 absent
Loss of TX reception
TX contact closed
or 8K2 present
TX contact open
Input 2
or 8K2 absent
Loss of TX reception
No TX programmed
Normal
Transmitter
(TX) battery
level
Quite low
Too low
* The flashing frequency of the blue LED (LEDR) indicates the number of the transmitters (TX) registered, with a 3-second gap in between.
**When the battery is quite low, the blue LED (LEDR) starts to flash very quickly ~10 times, then change to slow flashing to indicate the number of the transmitter (TX) with the battery level that is
quite low. If there are multiple faults, each transmitter (TX) number is spaced 2 seconds apart.
***When the battery is too low, the blue LED (LEDR) and the red LEDs (LED1 and LED2) start to flash very fast ~10 times, then the three LEDs (LEDR, LED1 and LED2) will flash slowly (to indicate
the number(s) of the transmitter(s) with the battery level that is too low). If there are multiple faults, each transmitter (TX) number is spaced 2 seconds apar.
LEDRBlue LED1Red
- ON
- OFF
- Rapid flashing
- -
- -
- -
ON -
Flashing =
number of TXs in -
memory*.
Flashing =
number of TX -
concerned**.
Flashing = Flashing =
number of TX number of TX
concerned***. concerned***.
LED2Red RELAY 1
- ON
- OFF
- OFF
ON -
OFF -
Rapid flashing -
- -
- -
- -
Flashing =
number of TX OFF
concerned***.
16
RELAY 2 BUZZER & LED4Green
- -
2 beeps if TX input = dry contact
-
3 beeps if TX input = 8K2
- 6 beeps every 30 s
ON
-
(If DIP3=OFF)
OFF 2 beeps if TX input = dry contact
(If DIP3=OFF) 3 beeps if TX input = 8K2
OFF
6 beeps every 30 s
(If DIP3=OFF)
- -
- -
ON
4 beeps every 30 s
(If DIP3=ON)
ON
5 beeps every 30 s
(If DIP3=ON)