Clearing Rx Or Tx Memory - Prastel Tco7Sg-Kit Benutzerhandbuch

TCO7SG-KIT
B. Clearing RX or TX memory
To erase memory completely, hold down the programming button of the module to be erased (RX or TX) for more than 5 seconds,
then press it again briefly to confirm the memory erasure.
If there is no second press to confirm the memory erasure, the module will exit memory clearing mode after more than 5
seconds.
Clearing the receiver (RX) memory (erasure of all registered TXs)
Press the PROG.RX button for more than 5 seconds.
1
Release the PROG.RX button, then press it again
2
3
The erasure is confirmed.
Clearing the transmitter (TX) memory (TX put into sleep mode)
Press the PROG.TX button for more than 5
1
PROG.TX button
Release the
2
3
The erasure is confirmed.
868Mhz radio bridge
☛
⏱>5 s
☛
⏱>1 s
seconds.
☛
⏱>5 s
, then press it again.
☛
⏱>1 s
The receiver will emit a sequence of bips
and LEDs R, 1 and 2 will flash rapidly
The receiver will emit 2 beeps and LED R will flash twice,
then LEDs R, 1 and 2 will flash rapidly.
x 2
The transmitter LED will flash rapidly.
The transmitter LED will flash once slowly, then 3
14
ISTCO7SG-KIT_EU_1224
x 2
times quickly.
1 long
x
.
3
x fast