Installation; Reviewing Defaults - Dawicontrol DC-29160 U3W Handbuch

Manual
II. Installation

1. Reviewing Defaults

The factory settings of the SCSI host adapter DC-2980 U3W were chosen to
make modifications in jumper settings unnecessary in most cases. Yet prior to
installation you should verify that the jumper settings are in accordance with the
recommended defaults.
Illustration: DC-29160 U3W
Jumper J4 + J5
No jumper set
Position 1-2
Position 2-3
Automatic termination means that the SCSI host adapter automatically checks
whether any devices are connected to the internal and/or external devices and turns
the terminators on or off accordingly. This setting should only be changed if problems
arise from special configurations.

2. Installation

To install the DC-29160 U3W SCSI Host Adapter you will have to remove the
cabinet of your computer; please note the warranty agreement of your computer
manufacturer. Before removing the cabinet always turn off and unplug your computer!
The DC-29160 U3W can be installed into any available bus master PCI-slot.
SCSI host adapter termination
off
on
automatic (default)
- 39 -