Cleaning The Appliance; Proceed As Follows; Interior Fittings; Light (Led) - Bosch KAN Serie Montage- Und Gebrauchsanleitung

en

Cleaning the appliance

m
Warning
Never clean the appliance with a steam cleaner!
m
Caution
Do not use abrasive, chloride or acidic cleaning
■
agents or solvents.
Do not use scouring or abrasive sponges. The
■
metallic surfaces could corrode.
Never clean shelves and containers in
■
the dishwasher. The parts may become deformed!

Proceed as follows:

1. Before cleaning: Switch off the appliance.
2. Pull out mains plug or switch off fuse.
3. Take out the frozen food and store in a cool location.
Place the ice pack (if enclosed) on the food.
4. Wait until the layer of frost has thawed.
5. Clean the appliance with a soft cloth, lukewarm water
and a little pH neutral washing-up liquid. The rinsing
water must not run into the light.
6. Wipe the door seal with clear water only and then
wipe dry thoroughly.
7. After cleaning reconnect and switch the appliance
back on.
8. Put the frozen food back into the appliance.

Interior fittings

To clean the equipment, all variable parts of
the appliance can be taken out (see chapter Variable
interior design).
Note
To take out and clean the containers, open the doors
fully beyond 90°.
34
Removing the container
Pull out container all the way, lift to detach it from
the holder and take out.
To insert the container, place on the telescopic rails
and push into the appliance. Attach the container by
pressing it down.

Light (LED)

Your appliance features a maintenance-free LED light.
These lights may be repaired by customer service
or authorised technicians only.

Tips for saving energy

Install the appliance in a dry, well ventilated room!
■
The appliance should not be installed in direct
sunlight or near a heat source (e.g. radiator, cooker).
If required, use an insulating plate.
Do not block the ventilation openings in
■
the appliance.
Allow warm food and drinks to cool down before
■
placing in the appliance.
Thaw frozen food in the refrigerator compartment
■
and use the low temperature of the frozen food
to cool refrigerated food.
Open the appliance as briefly as possible.
■
Ensure that the freezer compartment door is always
■
closed properly.
If available:
■
Fit wall spacers to obtain the indicated energy rating
of the appliance (see "Installing the appliance",
section "Ventilation"). A reduced wall gap will not
restrict the function of the appliance. The energy
rating may then increase slightly.
The arrangement of the fittings does not affect the
■
energy rating of the appliance.