Cleanmaxx Pro DMW006 Bedienungsanleitung Seite 16

EN
FILLING THE
FRESH WATER TANK
Please Note!
■ Only use non-foaming cleaning
products.
1. Remove the fresh water tank (12) from
the device and open it (see the "Attach­
ing and Detaching Accessories" chapter).
2. Fill with clean water (max. 40°C). Note
the WASSER (water) marking (13)!
3. If necessary, fill in detergent. Do not
exceed the REINIGUNGSMITTEL
( detergent) marking (14)!
4. Close and insert the fresh water tank.
USE
Please Note!
■ Note the MAX marking on the dirty
water tank. Do not exceed it to prevent
the motor from being overloaded.
■ Empty the dirty water tank regularly,
but whenever the MAX mark is
reached (see the "Cleaning the Device"
chapter).
■ Place the device on a waterproof
surface.
■ Clean the filter grill (23) regularly to pre­
vent the motor from being overloaded.
L
If you use the device with clean-
ing products, there may be some
foaming beneath the device.
This does not constitute a defect
and is harmless.
16
Preparation
• Remove coarse dirt beforehand with
a standard vacuum cleaner.
• If there is a lot of dirt, first spray addi­
tional cleaning agent onto the surface
to be cleaned and spread it around with
a brush if necessary. It is essential to
follow the instructions on the bottle of
the cleaning agent.
• Attach the required accessories (see the
"Attaching and Detaching Accessories"
chapter).
• Make sure that the fresh water tank (12)
is filled (see the "Filling the Fresh Water
Tank" chapter) and both tanks are
inserted in the motor unit (6).
Operation
• Switch on / off: Press the
• Spraying (Picture D: 1.): Press the
spray button (9) on the handle and
moisten the surface to be cleaned.
• Scrubbing (Picture D: 2.): Use the
attachment and gentle pressure to scrub
the surface to be cleaned.
• Suction (Picture D: 3.): Pull the nozzle
opening with gentle pressure over the
surface to be cleaned. The liquid is col­
lected in the dirty water tank (4).
• When the fresh water tank is empty or
the dirty water tank is full, switch off the
device. Only after this should you fill
or empty the appropriate tank (see the
"Cleaning the Device" chapter).
L
Place the nozzle on a cloth as resid­
ual water may escape after it has
been switched off.
button (2).