Cleanmaxx Pro DMW006 Bedienungsanleitung Seite 15

■ Do not make any modifications to the device. Also do not replace
the connecting cable yourself. If the device, the connecting cable or
the accessories of the device are damaged, they must be replaced
by the manufacturer, customer service department or a specialist
workshop in order to avoid any hazards.
WARNING – Danger of
Electric Shock
■ Never immerse the motor unit and the
connecting cable in water or other
liquids and ensure that they cannot fall
into water or become wet.
■ If the motor unit falls into water while it
is connected to the mains power, switch
off the power supply immediately! Only
after this should you pull the motor
unit from the water.
■ Never touch the motor unit and the con­
necting cable with wet hands when they
are connected to the mains power.
WARNING – Danger of Fire!
■ Do not cover the device during opera­
tion in order to prevent it from catching
fire. Do not insert anything into the ven­
tilation openings of the device and make
sure that they do not become clogged.
NOTICE – Risk of Damage to
Material and Property
■ Only connect the mains plug to a plug
socket that matches the technical data
of the device.
■ Only use suitable extension cables (max.
3 m) whose technical data is the same as
that of the device.
■ Do not use the device if there is visible
damage to the device or to the compo­
nent parts of the device.
■ In the event of damage / faults, switch
the device off immediately.
■ The device should only be used if it has
been fully and correctly assembled! The
tanks must be inserted and must
not be damaged! If dirt were to get
inside the motor unit, this could damage
the motor.
■ Do not exceed the maximum capacity of
the tanks!
■ Make sure that the device does not tip
over so that no water can run out of the
tanks.
ATTACHING AND
DETACHING ACCESSORIES
Dirty / Fresh Water Tank
• Removing: Use the lid handle to pull
the tank (4 or 12) away from the motor
unit (6) at a slight angle.
• Inserting: Place the tanks with the lid
closed into the motor unit (Picture A).
They must engage.
• Opening / closing: To open, lift up the
closure tab on the lid (3 or 15).
When closing, the closuere tab must
engage.
Nozzles
• Attaching: Slide the nozzle (17 or 20)
onto the handle (10). The nozzle release
button must engage.
• Detaching: Press the nozzle release
button (11) and pull the nozzle off.
• The attachment (18 or 19) on the wide
nozzle (17) can be exchanged (Picture
E: 1.).
• To clean the wide nozzle (17), the
transparent cover can be removed
( Picture E: 2.).
EN
15