Appliance Self Test; Starting The Appliance Self Test; Ending The Appliance Self Test; Customer Service - Bosch KAD-Serie Gebrauchs- Und Montageanleitung

Water and ice dispenser
Fault
Despite prolonged operating time, Despite prolonged operating time,
ice cubes are not being dispensed. ice cubes are not being dispensed.
Despite prolonged operating time,
ice cubes are not being dispensed.
Ice cubes are in the ice cube container
but are not being dispensed.
Ice cubes are jammed in the outlet
of the ice cube container or in the ice
crusher.
Ice cubes are watery.
Water dispenser is not functioning. Water dispenser is not functioning.
The ice maker does not make enough
ice or the ice is deformed.

Appliance self test

Your appliance features an automatic
self test program which shows you
sources of faults which may be repai
red by customer service only.
Starting the appliance
self test
S Switch off the appliance and wait
5 minutes.
S Switch on the appliance again.
S Simultaneously press button +" and
-" button for 5 seconds.
The self test programme starts. If E.."
is indicated on the display panel,
an error has occurred. If a fault is
indicated, inform customer service.

Ending the appliance self test

S Press the +" and -" buttons again
for 5 seconds.
Possible cause
Tap turned off.
Water supply is interrupted.
Water pressure too low.
Ice maker is disconnected.
Ice and water dispenser is switched off.
IWD off" is lit on the display panel.
Freezer compartment too warm.
Ice cubes are frozen together.
Ice cubes have melted power failure or
the freezer compartment door was not
closed properly.
Tap turned off.
Water supply is interrupted.
Water pressure too low.
The appliance or ice maker has only
just been switched on.
A lot of ice has been taken.
Low water pressure.
The water filter is bunged up or used.

Customer service

Your local customer service can be
found in the telephone directory or in
the customer service index. Please
provide customer service with the ap
pliance product number (E Nr.) and
production number (FD).
This information can be found on the
product label.2
Remedial action
Turn on tap.
Inform plumber.
Switch on ice maker again (see Disconnecting ice and
water dispenser, ice maker").
Switch on ice and water dispenser again (see Switching off
ice and water dispenser").
Set temperature colder in the freezer compartment
(see Selecting the temperature").
Remove and empty the ice cube container.
Remove the ice cube container and rotate the screw conveyor
by hand. Loosen any jammed chunks of ice with a wooden
chopstick.
Remove the ice cube maker, empty and rub dry.
Turn on tap.
Inform plumber.
Approx. 24 hours is needed until ice production starts.
Approx. 24 hours is needed until the ice cube container
is filled again.
Connect appliance to the prescribed drinking water supply
(see Installing and connecting the appliance",
Water connection").
Change the water filter.
To prevent unnecessary call outs, plea
se assist customer service by quoting
the product and production numbers.
This will save you additional costs.
en
39