Error Codes - Decathlon Riverside 100E Bedienungsanleitung

Error codes

System errors (flashing LED on control)
Fault code
1
2
3
4
5
6 Program error in the controller
7/8
9
10
11 Bicycle speed not recognised
ALL FLASH (LEDs
from 1 to 11)
10 11
9
8
Definition
Low battery voltage
Motor overheating
Abnormal current or power
Battery power surge
Frequency sensor error
Motor power surge
Motor error
Motor error or short circuit
Complex error
7
6
5
1-Switch off the bike and then switch it back on again
2-Charge the battery.
1-Let the motor rest by reducing the assistance mode.
2-turn off the bike, let it rest for a moment before turning it back on.
1-Switch off the bike and switch it back on again
2-Check that the connectors are fully inserted and the cables aren't damaged.
Charge the battery.
1-Switch off the bike and then switch it back on again.
2-Visit your Decathlon workshop to carry out a battery diagnosis.
1-Switch off the bike and switch it back on again.
2- Appointment at your Decathlon workshop to carry out a software update
1-Switch off the bike and switch it back on again.
2- Appointment at your Decathlon workshop to carry out a software update
1-Let the motor rest by reducing the assistance mode.
2-turn off the bike, let it rest for a moment before turning it back on.
1-Switch off the bike and switch it back on again.
2-Check that the motor connectors are firmly seated and the wheel can run
freely.
1-Switch off the bike and switch it back on again.
2-Check that the motor connections are properly plugged in.
1-Switch off the bike and switch it back on again.
1-Switch off the bike and switch it back on again.
2-Visit your Decathlon workshop for a complete diagnosis
18
4
3
2
1
Solutions