Werbung
Verfügbare Sprachen
Verfügbare Sprachen
So you can avoid clumping of the mix. If required, allow the adhesive to
stand for 5 to 10 min, and then mix again for some minutes.
Premixed plaster and ready-mixed mortar
The stirrer is well suited to mix ready-mixed mortar, plaster and the like.
Automix is not designed to mix concrete or mortar with medium-size gravel
and admixtures.
To prepare ready-mixed mortar or plaster, process as described in section
'Floor and Wall Tile Adhesives' above.
Since mortar is heavily hygroscopic, in view of excessive mix hardening it is
necessary to carefully observe the quantities of adhesive, cement or
additives for the desired mix.
Epoxy Resins
To process epoxy resins, it is necessary to check the viscosity and the
specific weight of the mix to be prepared in order to avoid overload of the
Automix tool. Fill the quantities of resin, hardener and powder as advised
by the producer into the bucket. Carefully mix the components in order to
avoid formation of bubbles or clumps
Paints
Fill the paint into the bucket and add the quantity of water or admixtures
required for the solution.
IMPORTANT!
The use of chemicals or solvents may impair the properties
!
of the bucket. Before using the Automix tool, check the
products to be mixed for compliance with the tool
manufacturer's requirements.
Removal of the Bucket
On putting-up the protective grid there is danger of
crushing. Therefore wear protective gloves!
Switch the tool off and wait until the stirring rod has stopped.
Open the locking.
Move the protective grid out of the bucket.
Move the bucket out of the framework. By means of the transport cart
you can move the mixture to the place of action.
Attention! Don't lift full buckets out of the tool alone!
23
Werbung
