Intended Use; Contraindications; Installation Of Batteries - Bbluv Basa Bedienungsanleitung

EN FR
Complies with the European Medical Device Directive
(93/42/EEC), Notified Body is SGS Belgium NV.
Conforme à la directive européenne sur les dispositifs
médicaux (93/42/CEE), l'organisme notifié est SGS
1639
Belgium NV.
Authorized representative in the European
Community. / Représentant autorisé dans la
Communauté européenne.
Attention: see Instructions for use! /
mode d'emploi !
Caution! Consult accompanying documents. /
Attention ! Consulter documents d'accompagnement.
Type BF applied parts /
Batch code / Code de lot
Serial number /
Manufacturer information /
Date of manufacture /
IP code of the device: this device's grade of against
ingress of solid foreign objects /
degré d'étanchéité de l'appareil à la pénétration de
corps étrangers solides.
Disposal in accordance with Directive 2002/96/EC
(WEEE) / Élimination conformément à la directive
2002/96/CE (DEEE)
EN

INTENDED USE

This product is used for measuring human body
temperature in medical department or home. This product
can be used to measure the temperature of infants,
children and adults. We recommend adults to operate the
thermometer instead of babies and children.

CONTRAINDICATIONS

Do not use local lesions such as inflammation, trauma and
postoperative. It is forbidden for those who are allergic to
stainless steel and ABS plastic.

INSTALLATION OF BATTERIES

1. This product uses One CR1632 button battery and has
been built into the thermometer body when it leaves the
factory. (Note: The built-in battery in the thermometer is a
trial battery. This battery may not provide the same life as
the new battery.)
2. To replace the battery, turn the screwdriver countercl o -
ckwise to remove the screw on the battery cover.
3. Gently remove the battery cover, then take out the old
battery.
4. Follow the battery polarity mark in the battery
compartment and put the new battery into the battery
compartment. When installing, pay attention to the positive
and negative polarity.
5. Reinstall the battery cover as is, and use ascrewdriver to
turn clockwise to tighten the fixing screws.
2
Attention : voir le
Type BF parties appliquées.
Numéro de série
Informations du fabricant
Date de fabrication
Code IP de l'appareil :
USE
Adjusted mode / Direct mode :
1. Tap the "power key", the thermometer will display in full
screen, and then display the effective memory
temperature value measured last time.
Tap the
« power key »
2. If adjusted mode was used last time, then this measure-
ment is also adjusted mode.
Automatic
conversion
If direct mode was used last time, this measurement will
also be in direct mode.
Automatic
conversion
Note : In direct mode, the screen displays the "
mode icon.
3. When the icon "°C" or "°F" on the screen begins to blink,
place the temperature sensor of the thermometer in the
following test parts :
Mesuring
Mesuring method
part
Raise your arm, Place the probe ti p
under the armpit parallel to the arm,
Under
pressing the arm against the body.
arm
Make sure the metal probe of the
thermometer is completely wrapped
around the armpit.
Place the thermometer in one of the
two locations under the tongue, to
the left or right of the root of the
tongue. The measuring probe must
Oral
be in good contact with the tissue.
Close your mouth and breathe
evenly through the nose to prevent
the measurement from being
influenced by inhaled/ exhaled ai r .
This is the most reliable measuring
method, and is especially suitabl e
for infants and small children.
Lay the baby on its back on a hard
surface and lift its legs to an angle
of approximately 90°. Hold them by
Rectal
the ankles in order to prevent thei r
body from turning while taking the
temperature. Carefully insert the
measuring probe of the
thermometer 2 to 3cm into the anal
aperture. Until the thermometer' s
metal probe is completely covered.
Automatic
display memory
" direct
Graphic
3