Drilling Operation - Ronix 8615 Bedienungsanleitung

NOTE:
When driving wood screws, pre-drill pilot holes to make driving easier
and to prevent splitting of the work piece. See the chart.
Nominal Diameter Of Wood
Screw(mm)
OPERATION
CAUTION:
Always insert the battery cartridge all the way until it locks in place. If not,
it may accidentally fall out of the tool, causing injury to you or someone
around you. Hold the tool firmly with one hand on the grip and the other
hand on the bottom of the battery cartridge to control the twisting action.

DRILLING OPERATION

First, turn the adjusting ring so that the pointer points to the marking.
Then proceed as follows.
When drilling in wood, the best results are obtained with wood drills
equipped with a guide screw. The guide screw makes drilling easier by
pulling the bit into the work piece. To prevent the bit from slipping when
starting a hole, make an indentation with a center-punch and hammer
at the point to be drilled. Place the point of the bit in the indentation and
start drilling. Use a cutting lubricant when drilling metals. The exceptions
are iron and brass which should be drilled dry.
3.1
3.5
3.8
4.5
4.8
5.1
5.5
5.8
6.1
Recommended Size Of Pilot
Hole(mm)
2.0~2.2
2.2~2.5
2.5~2.8
2.9~3.2
3.1~3.4
3.3~3.6
3.7~3.9
4.0~4.2
4.2~4.4
23
User Manual