Drilling Tips - Ronix 2221 Bedienungsanleitung

INSERTING THE DRILL
First remove the mains supply from the socket. Turn the ring of the drill
chuck until the clamping jaws are open wide enough. Insert the drill into
the clamping jaws of the drill chuck.
WORKING WITH THE DRILLING MACHINE
Ensure that the mains power supply voltage is the same as the operating
voltage of your machine. For details, please see the type plate. Insert the
correct drill for the type of job to be performed. If necessary, adjust the bit
stop. Adjust the speed of the machine using the regulating wheel on the
operating switch. The more the operating switch is pressed in, the faster
the drill rotates. Set the direction switch to the desired direction of motion.
Never alter the position of the hammer drilling switch or the direction
switch when the machine is switched on. The machine is switched on by
pressing the operating switch. When the operating switch is released,
the machine stops. If you would like to use continuous operation press the
locking button while the operating switch is pressed. In order to switch
off the machine during continuous operation, press the operating switch
again and then let it go. Do not touch the drill chuck while the machine
is switched on.

DRILLING TIPS

- Always insert the correct size and type of drill or screwdriver.
- Set the machine to the correct speed.
- Always hold the machine tightly by the handle and second handle.
- When drilling wood and metal, set the hammer-drilling switch to drilling.
16
Impact Drill 13mm