Ronix 8615 Bedienungsanleitung Seite 26

CAUTION:
Pressing excessively on the tool will not speed up the drilling. In fact,
this excessive pressure will only serve to damage the tip of your bit,
decrease the tool performance and shorten the service life of the tool.
- A stuck bit can be removed simply by setting the reversing switch to
reverse rotation in order to back out. However, the tool may back out
abruptly if you do not hold it firmly.
- Always secure small work pieces in a vise or similar hold-down device.
SCREW DRIVING OPERATION
Adjust the adjusting ring to the proper torque level for your work. Place
the point of the driver bit in the screw head and apply pressure to the tool.
Start the tool slowly and then increase the speed gradually. Release the
switch trigger as soon as the clutch cuts in.
CAUTION:
- Make sure that the driver bit is inserted straight in the screw head, or
the screw and/or bit may be damaged.
- Always secure small work pieces in a vise or similar hold-down device.
- If the tool is operated continuously until the battery cartridge has
discharged, allow the tool to rest for 15 minutes before proceeding with
a fresh battery.
24
Cordless Impact Driver Drill