Drilling Operation - Ronix 2106B Bedienungsanleitung

- For model 2106C with keyless chuck
To install the bit, loose chuck by hand and place bit in the chuck as far
as it will go, and then tighten the chuck by hand. For fixing the bit well,
keep the chuck and switch on machine for some seconds.
To remove the bit, above mentioned procedure should be done vice versa.
SWITCH ACTION
CAUTION
Before plugging in the tool, always check to see the switch trigger
actuates properly and returns to the OFF position when released.
To start the tool, simply pull the switch trigger. Release the switch trigger
to stop. For continuous operation, pull the switch trigger and then puch
in the lock button. To stop the tool from the locked position, pull the
switch trigger fully, and then release it.
Operating switch
Locking button

DRILLING OPERATION

When drilling in wood, the best results are obtained with wood drills
equipped with a guide screw. The guide screw makes drilling easier by
pulling the bit into the work piece.
To prevent the bit from slipping when starting a hole, make and indentation
with a center ounce and hammer at the point to be drilled, place the point of
12
Electric Drill