Ronix 8615 Bedienungsanleitung Seite 24

Before actual operation, drive a trial screw into your material or a piece
of duplicate material to determine which torque level is required for a
particular application.
Adjusting Ring
Graduation
Pointer
ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and the battery cartridge is
removed before carrying out any work on the tool.
INSTALLING OR REMOVING DRIVER BIT OR DRILL
BIT
Turn the sleeve counter clockwise to open the chuck jaws. Place the bit
in the chuck as far as it will go. Turn the sleeve clockwise to tighten the
chuck. To remove the bit, turn the sleeve counterclockwise.
Sleeve
22
Cordless Impact Driver Drill