Ronix 8615 Bedienungsanleitung Seite 22

the neutral position.
SPEED CHANGE
To change the speed, first switch off the tool and then slide the speed
change lever to the «2» side for high speed or «1» side for low speed.
Be sure that the speed change lever is set to the correct position before
operation. Use the right speed for your job.
CAUTION:
- Always set the speed change lever fully to the correct position. If you
operate the tool with the speed change lever positioned halfway between
the «1» side and «2» side, the tool may be damaged.
- Do not use the speed change lever while the tool is running. The tool
may be damaged.
20
Cordless Impact Driver Drill
Switch Trigger
Speed change lever
2
1