Kinetec Data Capture Benutzerhandbuch Seite 26

Daily programming management
This function is only available if a USB key is connected. This function allows a pre-stored program to
be performed according to the current date. Each time the splint is switched on, the program
parameters corresponding to the current date will be preselected.





Erase from the planner list:

"All" button, to erase the whole planner list. A confirmation message is displayed.
"Selected line" button to directly erase the highlighted line. Caution: no confirmation message is displayed.
Print the daily protocol: the protocols are printed on the default Windows printer

 Undo changes and return to the main screen
 Validate the planner and return to the main screen
Note:
It is always possible to change the motion parameters before starting or during the rehabilitation
-
session.
Program planning is possible over a maximum period of about six months. For example: if the planner
-
start date is the 1
When planning dates are not consecutive, program parameters as of the earlier date are preselected.
-
For example: program No. 1 is scheduled for January 1
January 2, 3 and 4, each time the power is switched on, the settings of program 1 will be preselected.
This feature requires the programs to have been previously stored (see Chapter "Program
-
Management"
To set the date and time on the hand controller, see chapter "Setting the date and time"
-
When pressing the Cancel button, the following dialogue box is displayed:
-
The USB key is now ready to be used with the passive mobilisation splint .
Warning:
Warning:
KINETEC DATA CAPTURE™



of January, it will be not be possible to plan a program on or after 6
st
,
page 7).
-> Click Yes to return to the main screen (modifications will be lost)
-> Click No to return to the patient list
For maximum safety, the hand controller should always be given to the patient when the
appliance is used in rehabilitation.
Always check the motion parameters displayed on the hand controller before starting the
rehabilitation session.
 Program planner list

Calendar to select a date

List of programs stored on the USB key

 Button to add the previously selected date
and program number to the planner list
Select the program to add to the planner list

, program No. 2 is scheduled for Jan. 5. On
st
EN
of July.
th
,
page 11.
8/14