Commissioning; Rtm Econ A⁄U - Dimplex Smart-Rtc+ Rtm Econ A Montageanleitung Und Bedienungsanleitung

English

4.5 Commissioning

4.5.1 RTM Econ A⁄U
The RTM Econ A/U is commissioned as shown in Fig. 4.13 on
page 8. The correct sequence must be observed. The addresses
are allocated as shown in Fig. 4.13 on page 8.
NOTE
If 'Cn' appears on the RTM Econ A⁄U display, communication to the heat
pump manager has been interrupted. In this case, please check the wiring
and settings, and restart the devices if necessary.
Fig. 4.13:
EN-8
NOTE
If communication cannot be established, the address set on the
RTM Econ A⁄U and the BUS line must be checked.
NOTE
Activating the room temperature control or changing the room set
temperature can initially result in the room temperature being exceeded.
452115.66.39 · FD 9707
Smart-RTC+