Green Cell PowerBoost Air Bedienungsanleitung Seite 6

IMPORTANT: Items such as balloons, inflatable pool toys, etc. are designed to be used at very low pressures which may not be shown
on the display. To avoid damaging the item or endangering people and animals, exercise extreme caution and monitor the inflation level
of these items.
Modification of preset modes
After selecting a predefined pumping mode, you can change the target value. To make a change, press the button
marked ''+' or ''-'', or hold the button to quickly change the target value.
Advanced mode – pumping without using preset mode
The advanced user can use the compressor function without selecting a preset mode (no mode icons). To use the
advanced mode, press the on/off button. This will start the compressor and begin pumping. The PowerBoost Air can
pump up to 150 psi, so it is imperative that you keep an eye on the displayed parameters to ensure you do not
exceed the recommended pressure for the item you are pumping.
Entering a limit in advanced mode
End of compressor operation / interruption of pumping
The device will automatically stop compressor operation when the target pressure value is reached. If you want
to stop pumping early or are using advanced mode, press the on/off button to stop the compressor.
The device has the ability to set a target pressure limit. To set a
limit, press the function button several times until all predefined
mode icons turn off. Then, use the '+' and '-' buttons to enter the
target pressure value. To start inflating, press the on/off button.
6