Turning The Device On/Off - Green Cell Powerboost Air Bedienungsanleitung

IMPORTANT:
Charge the device fully (100%; 4 full segments) before first use.
●
To recharge the device, use a certified USB 5 V/2 A charger, and a certified USB cable.
●
The device cannot be used while charging.
●
The battery indicator is not displayed when the unit is powered via the DC input.
●
Turning the device on/off
Compressor function
Connecting the pump hose
To use the compressor, connect the pump hose to the device with the end marked in green. The other end of the
hose with a thread should be connected to the object you want to inflate.
IMPORTANT: The device does not allow pressure relief. To reduce the pressure in the pumped object caused by, for
example, selecting the incorrect mode, manually press the pin located in the center of the valve of the pumped
object. ATTENTION! Be very careful as the air coming from inside may be under high pressure.
Thread adapter
Some bicycles, e-bikes, mopeds, motorcycles or scooters may use the American valve standard. To inflate such
items, use the included adapter by screwing it directly into the compressor hose. Then you can connect the hose to
the object you want to inflate.
Inflation needle
Turning on
To start the compressor (pumping function), press and hold the on/off button (middle button).
Turning off
To turn off the device, press and hold the on/off button (middle button).
Automatic shutdown
● When the pumping function is activated, the device will turn off automatically after 5 minutes of
continuous operation (without user intervention) in order to protect against accidental operation.
● The device will automatically turn off after 5 minutes when its charge level reaches 100%.
● When the user interrupts the charging process (removing the USB-C plug from the port), the device will
automatically switch off after 5 minutes.
Some non-threaded items, such as balls, will require the use of a dedicated inflation
needle. Screw the needle in correctly and then place it in the inflation hole - a slight hiss
may be heard when attaching, which is a normal process. Once you have placed the
needle in the correct position, you can turn on the compressor.
IMPORTANT: You can use a needle to reduce the pressure in the object you are
inflating. To do this, place the needle itself in the appropriate hole. ATTENTION! Be very
careful as the air coming from inside may be under high pressure.
4