Ridder Assistent Comfort Plus Montageanleitung Seite 25

Apply the brakes:
WARNING!
!
Always apply the right and left brakes at the same time so that they do not wear out unevenly.
Check the brakes for correct setting and functionality before each use. The parking brake must
always be activated before using the seat. Stop using the walker if the brakes can no longer be
adjusted correctly.
The brakes must be readjusted from time to time due to wear.
If the braking performance decreases or is uneven, you have to re-tighten the brakes.
No further training is required to use the rollator.
1
2
Use of the seat:
CAUTION!
!
Only use the seat when the parking brake is activated. Do not being pushed while using the seat
or push anyone else. There is a risk of falling! The seat must only be used by one person at a
time. Do not use the walker if the ground is smooth or slippery.
Hand-brake (while walking)
1
Pull both brake levers up towards the handlebar
at the same time and with the same intensity.
To loosen it, just let it loose again. The harder
you pull, the greater the braking power. If the
braking power is too low despite firm pulling, the
brake may have to be re-adjusted.
Parking-brake (while sitting)
2
Press both brake levers down until they lock
and no longer snap back. Only then are the
wheels fixed and the walker cannot roll away.
To release, simply pull it back into the middle
position with light pressure.
Use
25