Replacing The Power Cable; Cleaning, Maintenance And Ordering Of Spare Parts; Storage; Disposal And Recycling - EINHELL GC-ET 3023 Originalbetriebsanleitung

GB
are had on dry grass.
Connect the power cable to the extension cable
n
and fasten this to the strain-relief clamp (Figure
6/Item A).
To switch on your grass trimmer, press the
n
ON/OFF switch (Fig. 6/Item 3).
To deactivate the grass trimmer, let go of the
On/Off switch (Figure 6 / Item 3).
Do not move the grass trimmer against the grass
until the switch is pressed, i.e. wait until the
trimmer is running.
For the correct cutting action, swing the grass
trimmer to the side as you walk forward, holding
it at an angle of approx. 30° as you do so (see
Figure 8 and Figure 9).
Make several passes to cut long grass shorter
step by step from the top (see Figure 10).
Use the guard hood to prevent unnecessary wear
on the line.
Keep the grass trimmer away from hard objects
in order to avoid unnecessary line wear.

8. Replacing the power cable

If the power cable for this equipment is damaged, it
must be replaced by the manufacturer or its after-
sales service or similarly trained personnel to avoid
danger.
9. Cleaning, maintenance and ordering
of spare parts
Always pull out the mains power plug before starting
any cleaning work.
9.1 Cleaning
Keep all safety devices, air vents and the motor
n
housing free of dirt and dust as far as possible.
Wipe the equipment with a clean cloth or blow it
with compressed air at low pressure.
We recommend that you clean the device
n
immediately each time you have finished using it.
Clean the equipment regularly with a moist cloth
n
and some soft soap. Do not use cleaning agents
or solvents; these could attack the plastic parts
of the equipment. Ensure that no water can seep
into the device.
Use a brush to remove deposits from the safety
n
guard.
16
9.2 Replacing the line spool
Important! Make sure that you pull out the power
plug before replacing the line spool!
Press the sides of the spool cover as shown and
n
remove the cover (Figure 7a).
Remove the empty line spool.
n
Thread the end of the line from the new line spool
n
through the eyelet in the spool mount (Fig. 7b)
and allow approx. 10 cm of line to project.
Fit the spool cover back in the spool mount.
n
When you start the equipment again the line will
n
be cut to the perfect length automatically.
Important! Bits of the nylon line could cause
injury when flung out!
9.3 Maintenance
There are no parts inside the equipment which
require additional maintenance.
9.4 Ordering replacement parts
Please quote the following data when ordering
replacement parts:
Type of machine
n
Article number of the machine
n
Identification number of the machine
n
Replacement part number of the part required
n
For our latest prices and information please go to
www.isc-gmbh.info
Spare line spool Art. no.: 34.056.95

10. Storage

Store the equipment and accessories out of children's
reach in a dark and dry place at above freezing
temperature. The ideal storage temperature is
between 5 and 30 °C. Store the electric tool in its
original packaging.

11. Disposal and recycling

The unit is supplied in packaging to prevent its being
damaged in transit. This packaging is raw material
and can therefore be reused or can be returned to
the raw material system.
The unit and its accessories are made of various
types of material, such as metal and plastic.
Defective components must be disposed of as
special waste. Ask your dealer or your local council.