Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
INSTALLATION
1.
Before installation, make sure that all devices to be connected are not powered.
2.
Place the bracket base on the supporting surface to mark the 4 fixing holes. Consider the position of
the slot placed on the bracket, used for the passage of the cable (see photo). Use the base as drilling
template.
3.
Fix the camera and the provided suitable spanner, taking care to place the cable on the seat present
in the bracket, in order to avoid pinching the cable.
4.
Place the bracket in a position suitable for shooting the selected images; the camera can be adjusted
on the HORIZONTAL and VERTICAL axis.
HORIZONTAL AND VERTICAL ADJUSTMENT
Loosen the ring on the bracket and the adjusting screw shown in the figure.
•
Point the camera at the desired position
•
Once the adjustment has been performed, tighten the screw with the grub screw and the suitable
•
spanner
Important!
Don't use the screw placed on the other side of the camera
5.
Connect the video output to the selected terminal device.
6.
Power the camera.
DS 1092-159
ADJUSTING SCREW
Power cable
Video input
Video out cable
Alimentation
23
Werbung
Inhaltsverzeichnis
