What To Do If; Possible Cause - Zanussi ZFU219WO Benutzerhandbuch

Never use sharp metal tools to scrape off frost from
the evaporator as you could damage it. However, when
the ice becomes very thick on the inner liner, complete
defrosting should be carried out as follows:
• pull out the plug from the socket;
• remove all stored food, wrap it in several layers of
newspaper and put it in a cool place;

What to do if...

Caution! Before troubleshooting, disconnect the
power supply. Only a qualified electrician or
competent person must do the troubleshooting that is
not in this manual.
Problem
Appliance does not
work
Appliance freezes
too much
The food is not
frozen enough
Heavy build-up of
frost on the door
seal
Unusual noises

Possible cause

Appliance is not switched on.
Mains plug is not plugged in or is loose.
Fuse has blown or is defective.
Socket is defective.
Temperature is set too cold or the appliance
is running in Super Freeze mode.
Temperature is not properly adjusted.
Door was open for an extended period.
A large quantity of warm food was placed in
the appliance within the last 24 hours.
The appliance is near a heat source.
Door seal is not air-tight.
Appliance is not level.
The appliance is touching the wall or other
objects.
A component, e.g. a pipe, on the rear of the
appliance is touching another part of the
appliance or the wall.
• keep the door open, and place a basin underneath
the appliance to collect the defrost water;
• when defrosting is completed, dry the interior
thoroughly.
• Replace the plug in the power socket to run the
appliance again.
Important! There are some sounds during normal use
(compressor, refrigerant circulation).
Switch on the appliance.
Insert mains plug.
Check fuse, replace if necessary.
Mains malfunctions are to be corrected by
an electrician.
Turn the temperature regulator to a warmer
setting temporarily or press "Super Freeze"
button to stop Super Freeze mode.
Please look in the initial Control Panel
section.
Open the door only as long as necessary.
Turn the temperature regulation to a colder
setting temporarily.
Please look in the installation location
section.
Carefully warm the leaking sections of
the door seal with a hair dryer (on a cool
setting). At the same time shape the warmed
door seal by hand so that it sits correctly.
Re-adjust the feet.
Move the appliance slightly.
If necessary, carefully bend the component
out of the way.
Solution
13