Jung RWM200 Betriebsanleitung Seite 48

CAUTION
Possible property damage!
The mounting of the device according
to vfdb 14/01 (Q) establishes a
permanent connection between the
mounting surface and the device. Thus,
a subsequent removal of the device
is prevented. It is difficult to carry out
maintenance. If the device is disassem-
bled, it can cause damage to the device
and the mounting surface.
f Use the additional adhesive film
only to prevent theft.
f Put the device in operation
before attaching the additional
adhesive film.
When performing this type of installation,
proceed as follows:
(1) Mount magnetic carrier.
f Observe chapter „Adhesive mounting
according to EN 14604:2005/AC:2008"
on page 47.
(2) Take the device into operation.
48
Operating Manual: RWM200 - Smoke Alarm Device
f Observe chapter 6 „Putting into
operation" on page 50.
(3) Attach additional adhesive film to
the magnetic carrier.
f Remove the protective film on one
side of the adhesive sheet.
f Put adhesive sheet on the magnetic
carrier and press on.
f Remove the protective film on the
other side.
(4) Put the device on the magnetic
carrier and press on.
5 The device is mounted on the
magnetic carrier.
5.2 Drilling installation
As an alternative to adhesive mounting,
you can also screw the magnetic carrier
on the mounting surface.
Even with the drilling installation, the ad-
hesive pad must remain on the magnetic
carrier and must not be removed.
When performing the drilling installation,
proceed as follows:
EN