Trouble Shooting; Specifications - Texas A/S El-Tex 1000 Bedienungsanleitung

9. Trouble Shooting

Problem
Engine does not start
Abnormal noise level
Abnormal vibrations
Bad results

10. Specifications

Reason
No power
Defective safety switch
Overheat protection active
Blades are blocked
Lack of grease
Loose bolts, nuts or safety
equipment.
Blades broken or worn
Work depth too big
Work depth too low
Worn blades
Model
Power supply
Watt
Work width
Max. work depth
Noise
Grease
Solution
Check power and cables
Contact local dealer
a. Work at lower depth.
b. Remove possible blockages.
c. The soil is too hard. Change
the work depth and go slowly for-
wards and backwards several
times. Do not restart for 15 min.
Stop the engine and await com-
plete stop. Remove the blockage.
Contact local dealer
Tighten. Contact local dealer, if
noise persists.
Replace or contact local dealer
Use correct work depth.
Use correct work depth.
Replace or contact local dealer
El-Tex 1000
230 Volt - 50 Hz
1000 Watt
360 mm
200 mm
93 dB(A)
Multifak Fedt / 90306500
16