Technical Specifications - Fancom I-Fan Modular Handbuch

Cleaning
The I-fan may be cleaned wet, but consider the following:
Do not use a high pressure hose or aim at motor seals or openings at close range.
Do not turn the I-fan during or after the cleaning process. Note that the air inlet side is always on the
bottom side.
After cleaning the I-fan, it should run at 100% rpm for at least 30 minutes to remove all dampness.
4.

Technical specifications

Housing
Protection class
Operating environment
Operating temperature range
Storage temperature range
Relative humidity
Gndfi
IP66
0°C to +40°C
-10°C tot 50°C
< 85%, not condensing
g
13