Maintenance Intervals - Abicor Binzel Mf1-Laser Front/Rear Betriebsanleitung

MF1-Laser Front/Rear
9.1 Inspecting the wire guide nipple
1
1 Wire guide at the MasterLiner wire inlet
Fig. 19 Wire guide nipple MF1

9.2 Maintenance intervals

NOTICE
• The specified maintenance intervals are standard values and refer to single-shift operation.
• Visually inspect the toothed wheels once a week.
• The higher the rocker arm force, the greater the wear to the toothed wheels.
When using arc welding equipment, always observe the provisions of EN 60974-4 Inspection and testing,
as well as any national laws and regulations.
Check the following:
Daily
• Visual inspection for abrasion or damage to the wire feed rolls.
Tab. 15 Maintenance intervals
2
2 Wire guide nipple between the drive wheels
Weekly
Basic cleaning is recommended, and necessary in the event of
extreme working conditions.
Blow compressed air through the wire conduit and check for
wear.
9 Maintenance and cleaning
3
3 Wire guide actual value transmitter
EN - 23